Page 121 - 电力与能源2024年第三期
P. 121
第 45 卷 第 3 期 电力与能源
2024 年 6 月 395
DOI:10.11973/dlyny202403026
U 型盾构与明挖现浇建设电力隧道走廊的
技术造价对比
徐 良,彭彩虹,蔡龙晟
(上海电力设计院有限公司,上海 200025)
摘 要:电缆隧道已成为不少输电走廊的首选建设形式,由于明挖现浇隧道施工工艺较为成熟,因此以往大量
的电力隧道以及综合管廊均采用此施工方案来实施。明挖现浇法存在施工断面及土方开挖量较大、施工环境
不友好,施工效率较低等缺点。针对上述这些缺点,目前在雄安新区等地,开始采用 U 型盾构机械施工来取
代明挖现浇电缆隧道施工。重点对比了两种施工方法的技术差异,同时比对了两种工艺的单位造价,并通过
实际案例中工程量和造价的对比分析,给出了 U 型盾构施工工艺经济规模的大致路径长度。
关键词:U 型盾构;明挖现浇隧道;电力隧道走廊
作者简介:徐 良(1984—),男,高级工程师,负责 35 kV 及以上电网输变电项目设计造价及标准的编制和评审。
中图分类号:U455.1;TM75 文献标志码:A 文章编号:2095-1256(2024)03-0395-03
Cost Comparison of Constructing Power Tunnel Corridors Using U-shaped Shield
Tunneling and Cut-and-Cast Tunnel
XU Liang,PENG Caihong,CAI Longsheng
(Shanghai Electric Power Design Institute Co.,Ltd.,Shanghai 200025,China)
Abstract:Cable tunnels have become the preferred construction form for many transmission corridors. Due to the
maturity of construction techniques, the cut-and-cast method has been widely adopted for the construction of
power tunnels and comprehensive pipe galleries in the past. However, the cut-and-cast method has disadvantages
such as large construction section and earthwork excavation volume, unfriendly construction environment, and
low construction efficiency. To address these drawbacks, the use of U-shaped shield tunneling has begun in places
like Xiong'an New Area to replace the cut-and-cast construction of cable tunnels. This paper focuses on compar⁃
ing the technical differences between the two construction methods and compares the unit costs of the two tech⁃
niques. Through comparative analysis of engineering quantities and costs in actual cases, an approximate path
length for the economic scale of U-shaped shield tunneling construction is provided.
Key words:U-shaped shield tunneling,cut-and-cast tunnel,power tunnel corridor
城市的输配电网主要是通过建设架空走廊或 高压电缆的敷设效率上来看,电力隧道或者电力
者地下电缆的形式来实现。然而,随着城市建设 综合管廊是建设长距离超高压送电走廊的首选。
的不断推进以及对城市风貌要求的日益提高,以 截 至 2020 年 底 ,我 国 建 成 管 廊 总 里 程 约
往的架空走廊建设方式已经很难在中、大型城市 8 000 km。目前国内综合管廊建设大多以明挖+
的规划中获得许可。取而代之的是将 220 kV 及 主体现场浇筑为主,工厂化、机械化、信息化、绿色
以下的输配电网络通过地下走廊的形式进行建 化和智能化“五化”程度不高,没有形成系统的现
造,传统输电电缆敷设的施工方式一般为直埋敷 代化建造技术,不能满足新形势的需求。因此,预
设、非开挖或顶管敷设以及电缆沟排管敷设,但从 制装配式施工法应运而生,如海口管廊应用 U 型
日常电缆巡视、维护及检修的便利性,以及多条超 盾构+预制拼装法,雄安起步区应用 8 m 大节段